Inspecting run results at the model level

< Back

To inspect run results at the Model level, log-in to Test Modeller and open the Model from which the automated tests were generated.

Next, navigate to the “Test Generation” tab of the menu and select the Coverage Profile used to generate the automated tests. Click “Tests”:

Analysing Results_Inspecting Results at the Model Level_1a

This will open the Test Cases sidebar:

Analysing Results_Inspecting Results at the Model Level_2a

The Test Case sidebar provides pass/fail results by test case. These results are displayed by row, as either a green “Passed” icon, or a red “Failed”.

Results are browsed by test generation “History”: the date and time when the test cases  were generated. Use the History drop-down menu to browse test cases select the relevant run results.

Run results are displayed by test case. Clicking a test case row will highlight the path through the system model that the automated test has exercised.

You can analyse the results history for a given test case from the test case sidebar. Select  the cog icon next to the test cases and select “Results”. This will display the run result and Job Engine ID for the test case:

Analysing Results_Inspecting Results at the Model Level_3a

If you execute automated tests while the model is open, click the cog icon and then “Refresh”. This will refresh the run results associated with the model.

Previous Introduction
Next The run results page
Table of Contents